firstly i am not live trading as i am just starting out. so if u can offer advice on the following and u have some first hand experience i would be grateful..
I have a pc that was custom built a few years ago..
P3 733 MHz slot 1 133 FSB
384 Mb RAM P133
60 GB HDD
VIA ABIT VT6x4 motherboard on 133 BUS
MATROX MILLENIUM G400 graphics card..
Running WIN 98 SE..
Now before u collapse laughing pls read on...
Now the P3 is a recent upgrade (from 450 MHz) which i got from ebay with heatsink for £25.
There is a little improvement but when i ran deal4free demo today then tried to pull up 1 advfn chart things started to grind . I only had 2 other IE windows open....
Although resource meter showed about 30% free for GDI, system & user the sytem monitor showed KERNEL processor usage at 100%. I also noticed increase in DISK CACHE misses..
I havealready run the free diag from PCPITSTOP & have adjusted some setting & performed a DEFRAG.
so, where does that leave me gents.. ?
a)get a 1000MHz chip - although my M/board does not support it should work- will it make that much difference..??
b) change motherboard, processor & graphics card hopefully using existing RAM- cost.? not sure.
c) Go for high spec laptop- but thats lots of cash...
d) try to tweak- not sure if this is pointless bearing in mind what i am trying to do(Run 4 graphs at once plus broker application etc..etc.)
I have a pc that was custom built a few years ago..
P3 733 MHz slot 1 133 FSB
384 Mb RAM P133
60 GB HDD
VIA ABIT VT6x4 motherboard on 133 BUS
MATROX MILLENIUM G400 graphics card..
Running WIN 98 SE..
Now before u collapse laughing pls read on...
Now the P3 is a recent upgrade (from 450 MHz) which i got from ebay with heatsink for £25.
There is a little improvement but when i ran deal4free demo today then tried to pull up 1 advfn chart things started to grind . I only had 2 other IE windows open....
Although resource meter showed about 30% free for GDI, system & user the sytem monitor showed KERNEL processor usage at 100%. I also noticed increase in DISK CACHE misses..
I havealready run the free diag from PCPITSTOP & have adjusted some setting & performed a DEFRAG.
so, where does that leave me gents.. ?
a)get a 1000MHz chip - although my M/board does not support it should work- will it make that much difference..??
b) change motherboard, processor & graphics card hopefully using existing RAM- cost.? not sure.
c) Go for high spec laptop- but thats lots of cash...
d) try to tweak- not sure if this is pointless bearing in mind what i am trying to do(Run 4 graphs at once plus broker application etc..etc.)